Difference between revisions of "83Plus:Ports:86"

From WikiTI
Jump to: navigation, search
Line 1: Line 1:
 
[[Category:83Plus:Ports:By Address|86 - USB Miscellaneous Events]] [[Category:83Plus:Ports:By Name|USB Miscellaneous Events]]
 
[[Category:83Plus:Ports:By Address|86 - USB Miscellaneous Events]] [[Category:83Plus:Ports:By Name|USB Miscellaneous Events]]
 +
{{84P-Only Port|06}}
 
== Synopsis ==
 
== Synopsis ==
 
'''Port Number:''' 86h
 
'''Port Number:''' 86h
Line 6: Line 7:
  
 
This port reports when various device-level USB events occur.
 
This port reports when various device-level USB events occur.
 
{{84P-Only Port|06}}
 
  
 
=== Read Values ===
 
=== Read Values ===

Revision as of 21:19, 27 October 2011

This port only exists on the the TI-84 Plus and the TI-84 Plus Silver Edition. On the standard TI-83 Plus, it acts as a shadow of port 06. On the TI-83 Plus Silver Edition, this port has no effect.

Synopsis

Port Number: 86h

Function: USB Miscellaneous Events

This port reports when various device-level USB events occur.

Read Values

Reading from this port also clears it. Remember the value you read, because you can't go back and read it again.

  • Bit 0: Possibly set if the bus has been suspended (no activity for some length of time.)
  • Bit 1: Unknown; probably related to HNP and/or SRP.
  • Bit 2: Set if a bus reset has occurred (both D+ and D? pulled low for some length of time.)
  • Bit 3: Unknown.
  • Bit 4: Possibly set if a device has been connected (D+, or maybe D?, pulled high for some length of time.)
  • Bit 5: This usually indicates that something was unplugged.
  • Bit 6: Unknown; probably related to HNP.
  • Bit 7: Calculator cannot provide sufficient power. Usually caused by low batteries, although, some devices cause this every time.

Write Values

  • No effect

Comments

This port is used to report various bus events, which are not associated with any particular endpoint. Note that this port (probably) only works if port 5B bit 0 is set. Port 8B might also act as a mask for this port (note that that port is normally set to A1h in host mode, and 05h in peripheral mode.)