Thepenguin77 at 04:26, 28 October 2011

2011-10-28T04:26:25Z

FloppusMaximus: Port 9A: endpoint type/address for reading

2010-11-15T05:25:21Z

Port 9A: endpoint type/address for reading

New page

[[Category:83Plus:Ports:By Address|9A - USB Read Endpoint Type/Address]] [[Category:83Plus:Ports:By Name|USB Read Endpoint Type/Address]]
== Synopsis ==
'''Port Number:''' 9Ah

'''Function:''' USB Read Endpoint Type/Address

This port determines the endpoint address and transaction type to use when reading from a USB pipe.

{{84P-Only Port|10}}

=== Read Values ===
* Unknown

=== Write Values ===
* Bits 0-3: Source endpoint number (bEndpointAddress.)
* Bits 4-5: Endpoint type (bmAttributes.)
* Bits 6-7: No effect.

== Comments ==
Each of the USB controller's internal "pipes" (with the possible exception of pipe 0) can be used to send and receive bulk, interrupt, and/or isochronous data packets. This port determines which type of transaction, and which USB endpoint, should be used for data read from the current pipe. (The "current" pipe is determined by [[83Plus:Ports:8E|port 8E]].)

The low 4 bits of this port are the USB endpoint address, corresponding to the low bits of the bEndpointAddress field in the endpoint descriptor. (Both the OS and USB8x will always use pipe ''n'' for reading from endpoint ''n''; i.e., the low bits of this port will be set to the same value as port 8E. This is probably a good convention to stick to when possible; the effects of remapping endpoints haven't been fully explored.)

Bits 4-5 are the endpoint type, corresponding to bits 0-1 of the bmAttributes field in the endpoint descriptor:
* 10h = isochronous
* 20h = bulk
* 30h = interrupt
(The transaction type will affect the wire protocol used, and may affect how the controller chooses to schedule parallel transactions in host mode.)

In addition to this port, you should also initialize [[83Plus:Ports:93|port 93]] (wMaxPacketSize), and possibly [[83Plus:Ports:9B|port 9B]] (bInterval), before requesting data from the pipe. Once the pipe is fully configured for reading, use [[83Plus:Ports:94|port 94]] to request data.

@@ Line 1: / Line 1: @@
 [[Category:83Plus:Ports:By Address|9A - USB Read Endpoint Type/Address]] [[Category:83Plus:Ports:By Name|USB Read Endpoint Type/Address]]
 == Synopsis ==
 '''Port Number:''' 9Ah
@@ Line 6: / Line 7: @@
 This port determines the endpoint address and transaction type to use when reading from a USB pipe.
 === Read Values ===

83Plus:Ports:9A - Revision history

Thepenguin77 at 04:26, 28 October 2011

FloppusMaximus: Port 9A: endpoint type/address for reading