Difference between revisions of "83Plus:OS:RST Routines"
From WikiTI
m (heard about this on #cemetech IRC) |
|||
| (3 intermediate revisions by 2 users not shown) | |||
| Line 1: | Line 1: | ||
[[Category:83Plus:OS_Information|RST Routines]] | [[Category:83Plus:OS_Information|RST Routines]] | ||
| − | |||
== Introduction == | == Introduction == | ||
| Line 11: | Line 10: | ||
|-[[83Plus:BCALLs:412F|OP1ToOP2]] || rOP1ToOP2 | |-[[83Plus:BCALLs:412F|OP1ToOP2]] || rOP1ToOP2 | ||
|- | |- | ||
| − | |[[83Plus:BCALLs: | + | |[[83Plus:BCALLs:42F4|FindSym]] || rFindSym |
|- | |- | ||
|[[83Plus:BCALLs:43BA|PushRealO1]] || rPushRealO1 | |[[83Plus:BCALLs:43BA|PushRealO1]] || rPushRealO1 | ||
| Line 19: | Line 18: | ||
|[[83Plus:BCALLs:4072|FPAdd]] || rFPAdd | |[[83Plus:BCALLs:4072|FPAdd]] || rFPAdd | ||
|} | |} | ||
| + | |||
== Example == | == Example == | ||
| Line 36: | Line 36: | ||
You cannot define your own RSTs; they are part of the operating system. | You cannot define your own RSTs; they are part of the operating system. | ||
| + | <nowiki>rst 00 is the OS reset | ||
| + | rst 28h is BCALL | ||
| + | rst 38h is the interrupt routine</nowiki> | ||
Latest revision as of 15:16, 13 July 2020
Introduction
The Z80 restart instruction, or RST, can be used instead of a B_CALL for some system entry points. The advantage is that using the RST instruction takes only one byte, instead of the three bytes required for a B_CALL, and is very quick when compared with the relatively large overhead inherent of a B_CALL.
RST Routines
All the RST routines work exactly the same as the corresponding B_CALLs:
| B_CALL | RST |
| FindSym | rFindSym |
| PushRealO1 | rPushRealO1 |
| Mov9ToOP1 | rMov9ToOP1 |
| FPAdd | rFPAdd |
Example
rst rFPAdd
Equates
rOP1ToOP2 EQU 08h rFindSym EQU 10h rPushRealO1 EQU 18h rMov9ToOP1 EQU 20h rFPAdd EQU 30h
Remarks
You cannot define your own RSTs; they are part of the operating system.
rst 00 is the OS reset rst 28h is BCALL rst 38h is the interrupt routine
