Difference between revisions of "83Plus:RAM:8447"
From WikiTI
m (Formatting fun) |
|||
| Line 14: | Line 14: | ||
add a, 0D8h | add a, 0D8h | ||
out (10h), a | out (10h), a | ||
| − | CALL 000Bh ;Delay required time, or find some other way to waste/use 60 cycles. | + | CALL 000Bh ;Delay required time, or find some other way to waste/use 60 cycles.</nowiki> |
| − | </nowiki> | + | |
This simple routine sets both the system contrast and the LCD contrast to whatever is in A (valid range is 00~27h, does nothing if out of range). | This simple routine sets both the system contrast and the LCD contrast to whatever is in A (valid range is 00~27h, does nothing if out of range). | ||
| Line 26: | Line 25: | ||
pop af | pop af | ||
ret | ret | ||
| − | ;Waste/Use ~45 cycles before accessing LCD directly. | + | ;Waste/Use ~45 cycles before accessing LCD directly.</nowiki> |
| − | </nowiki> | + | |
Revision as of 10:05, 21 April 2005
Synopsis
Official Name: contrast
Memory Address: 8447h
Length: 1 byte.
This area holds the system contrast value. When you press 2nd+Up or 2nd+Down while in a GetKey, GetKey automatically increases or decreases this value and updates the LCD's contrast. The accepted range of this value is 00h ~ 27h.
Comments
Changing this value does not "instantly" update the LCD contrast; you must manually update the LCD. To set the LCD contrast to match the calculator's, add D8h to the read value and output to Port 10h:
ld a, (contrast) add a, 0D8h out (10h), a CALL 000Bh ;Delay required time, or find some other way to waste/use 60 cycles.
This simple routine sets both the system contrast and the LCD contrast to whatever is in A (valid range is 00~27h, does nothing if out of range).
cp 28h ret nc ;NC means >= which is bad, so bail out. ld (contrast), a push af add a, 0D8h out (10h), a pop af ret ;Waste/Use ~45 cycles before accessing LCD directly.
