84PCE:Ports:A000: Difference between revisions

From WikiTI
Jump to navigationJump to search
No edit summary
No edit summary
Line 9: Line 9:


Bits 0-1: Scan mode
Bits 0-1: Scan mode
Mode 0: Idle.
 
Mode 1: Indiscriminate key detection. Data registers are not updated, but whenever any key is pressed, interrupt bit 2 is set (and cannot be cleared until the key is released).
*Mode 0: Idle.
Mode 2: Single scan. The keypad is scanned once, and then the mode returns to 0.
 
Mode 3: Continuous scan. When scanning completes, it just starts over again after a delay.
*Mode 1: Indiscriminate key detection. Data registers are not updated, but whenever any key is pressed, interrupt bit 2 is set (and cannot be cleared until the key is released).
 
*Mode 2: Single scan. The keypad is scanned once, and then the mode returns to 0.
 
*Mode 3: Continuous scan. When scanning completes, it just starts over again after a delay.
 
Bits 2-15: Number of APB cycles to wait before scanning each row
Bits 2-15: Number of APB cycles to wait before scanning each row
Bits 16-31: Number of APB cycles to wait between scans
Bits 16-31: Number of APB cycles to wait between scans

Revision as of 09:28, 31 March 2015

Synopsis

Port Number: A000-A003

Memory-mapped address: F50000

Function: Set the mode of the keypad controller

Bits 0-1: Scan mode

  • Mode 0: Idle.
  • Mode 1: Indiscriminate key detection. Data registers are not updated, but whenever any key is pressed, interrupt bit 2 is set (and cannot be cleared until the key is released).
  • Mode 2: Single scan. The keypad is scanned once, and then the mode returns to 0.
  • Mode 3: Continuous scan. When scanning completes, it just starts over again after a delay.

Bits 2-15: Number of APB cycles to wait before scanning each row Bits 16-31: Number of APB cycles to wait between scans