Difference between revisions of "84PCE:Ports:A000"
From WikiTI
(→Synopsis) |
|||
| Line 4: | Line 4: | ||
'''Port Number:''' A000-A003 | '''Port Number:''' A000-A003 | ||
| − | '''Memory-mapped address:''' F50000 | + | '''Memory-mapped address:''' F50000-F50003 |
'''Function:''' Set the mode of the keypad controller | '''Function:''' Set the mode of the keypad controller | ||
Revision as of 01:29, 31 March 2015
Synopsis
Port Number: A000-A003
Memory-mapped address: F50000-F50003
Function: Set the mode of the keypad controller
Bits 0-1: Scan mode
- Mode 0: Idle.
- Mode 1: Indiscriminate key detection. Data registers are not updated, but whenever any key is pressed, interrupt bit 2 is set (and cannot be cleared until the key is released).
- Mode 2: Single scan. The keypad is scanned once, and then the mode returns to 0.
- Mode 3: Continuous scan. When scanning completes, it just starts over again after a delay.
Bits 2-15: Number of APB cycles to wait before scanning each row
Bits 16-31: Number of APB cycles to wait between scans
