Difference between revisions of "83Plus:Ports:2A"
(Added port info) |
(→Synopsis: this too) |
||
| Line 7: | Line 7: | ||
'''Function:''' LCD Delay (15 MHz) | '''Function:''' LCD Delay (15 MHz) | ||
| − | This port works in the same manner 29 does, but only when the calculator is set at 15mhz. It removes the amount of delay needed between accesses to the lcd driver by adding | + | This port works in the same manner 29 does, but only when the calculator is set at 15mhz. It removes the amount of delay needed between accesses to the lcd driver by adding a delay to any instruction which reads from or writes to ports [[83Plus:Ports:10|10]] or [[83Plus:Ports:11|11]], as well as the mirror ports 12 and 13. |
| − | + | ||
| − | + | ||
| − | + | ||
| − | + | ||
=== Usage === | === Usage === | ||
| − | Bits 0 | + | Bits 0 and 1 are unknown, but don't seem to directly remove the needed delay. They are set on both the 83+SE and 84+(SE). |
| − | + | ||
| − | + | ||
| + | Bits 2-7 control the amount of delay added at specified instructions. To calculate the number of clock cycles added divide the contents of port 2A by 4 and round off. '''NOTE:''' The contents of this port should NOT be less than 0Ch or the LCD will no longer update. | ||
== Comments == | == Comments == | ||
Revision as of 13:54, 8 August 2005
| This port only exists as a distinct port on the TI-83 Plus Silver Edition, the TI-84 Plus, and the TI-84 Plus Silver Edition. On the standard TI-83 Plus, it acts as a shadow of port 02. |
Synopsis
Port Number: 2Ah
Function: LCD Delay (15 MHz)
This port works in the same manner 29 does, but only when the calculator is set at 15mhz. It removes the amount of delay needed between accesses to the lcd driver by adding a delay to any instruction which reads from or writes to ports 10 or 11, as well as the mirror ports 12 and 13.
Usage
Bits 0 and 1 are unknown, but don't seem to directly remove the needed delay. They are set on both the 83+SE and 84+(SE).
Bits 2-7 control the amount of delay added at specified instructions. To calculate the number of clock cycles added divide the contents of port 2A by 4 and round off. NOTE: The contents of this port should NOT be less than 0Ch or the LCD will no longer update.
Comments
This port is not available on the normal TI-83+. On the normal TI-83+ this port is a shadow of Port 02h.
Bits 0&1 seem to tie to port 2E, they affect the cpu speed reduction the port 2e contorls. Though their exact purpose is not known.
