84PCE:Ports:A000: Difference between revisions

From WikiTI
Jump to navigationJump to search
No edit summary
Line 2: Line 2:
  [[Category:84PCE:Ports:By_Address|A000 - Keyboard]] [[Category:84PCE:Ports:By_Name|Keyboard]]
  [[Category:84PCE:Ports:By_Address|A000 - Keyboard]] [[Category:84PCE:Ports:By_Name|Keyboard]]
== Synopsis ==
== Synopsis ==
'''Port Number:''' A000-?
'''Port Number:''' A000-A003


'''Memory-mapped address:''' F50000
'''Memory-mapped address:''' F50000


'''Function:''' Keyboard array read
'''Function:''' Set the mode of the keypad controller


The ports in this range are for reading from the keyboard. More information to come soon.
Bits 0-1: Scan mode
Mode 0: Idle.
Mode 1: Indiscriminate key detection. Data registers are not updated, but whenever any key is pressed, interrupt bit 2 is set (and cannot be cleared until the key is released).
Mode 2: Single scan. The keypad is scanned once, and then the mode returns to 0.
Mode 3: Continuous scan. When scanning completes, it just starts over again after a delay.
Bits 2-15: Number of APB cycles to wait before scanning each row
Bits 16-31: Number of APB cycles to wait between scans

Revision as of 09:28, 31 March 2015

Synopsis

Port Number: A000-A003

Memory-mapped address: F50000

Function: Set the mode of the keypad controller

Bits 0-1: Scan mode Mode 0: Idle. Mode 1: Indiscriminate key detection. Data registers are not updated, but whenever any key is pressed, interrupt bit 2 is set (and cannot be cleared until the key is released). Mode 2: Single scan. The keypad is scanned once, and then the mode returns to 0. Mode 3: Continuous scan. When scanning completes, it just starts over again after a delay. Bits 2-15: Number of APB cycles to wait before scanning each row Bits 16-31: Number of APB cycles to wait between scans