Difference between revisions of "84PCE:Ports:A000"
From WikiTI
| Line 9: | Line 9: | ||
Bits 0-1: Scan mode | Bits 0-1: Scan mode | ||
| − | Mode 0: Idle. | + | |
| − | Mode 1: Indiscriminate key detection. Data registers are not updated, but whenever any key is pressed, interrupt bit 2 is set (and cannot be cleared until the key is released). | + | *Mode 0: Idle. |
| − | Mode 2: Single scan. The keypad is scanned once, and then the mode returns to 0. | + | |
| − | Mode 3: Continuous scan. When scanning completes, it just starts over again after a delay. | + | *Mode 1: Indiscriminate key detection. Data registers are not updated, but whenever any key is pressed, interrupt bit 2 is set (and cannot be cleared until the key is released). |
| + | |||
| + | *Mode 2: Single scan. The keypad is scanned once, and then the mode returns to 0. | ||
| + | |||
| + | *Mode 3: Continuous scan. When scanning completes, it just starts over again after a delay. | ||
| + | |||
Bits 2-15: Number of APB cycles to wait before scanning each row | Bits 2-15: Number of APB cycles to wait before scanning each row | ||
Bits 16-31: Number of APB cycles to wait between scans | Bits 16-31: Number of APB cycles to wait between scans | ||
Revision as of 01:28, 31 March 2015
Synopsis
Port Number: A000-A003
Memory-mapped address: F50000
Function: Set the mode of the keypad controller
Bits 0-1: Scan mode
- Mode 0: Idle.
- Mode 1: Indiscriminate key detection. Data registers are not updated, but whenever any key is pressed, interrupt bit 2 is set (and cannot be cleared until the key is released).
- Mode 2: Single scan. The keypad is scanned once, and then the mode returns to 0.
- Mode 3: Continuous scan. When scanning completes, it just starts over again after a delay.
Bits 2-15: Number of APB cycles to wait before scanning each row Bits 16-31: Number of APB cycles to wait between scans
