83:Ports:03: Difference between revisions

From WikiTI
Jump to navigationJump to search
Kalimero (talk | contribs)
redid bits 0,1,2
if interrupts are disabled, any value between 0 and 15 can be read
Line 22: Line 22:


== Comments ==
== Comments ==
* Outside an interrupt routine, this port always reads either 00h or 08h.
* You need to acknowledge interrupts. Otherwise a new interrupt will be generated directly after you enable interrupts again with EI. Because that disables that particular interrupt at the same time, you may have to write a second value to this port to reenable it.
* You need to acknowledge interrupts. Otherwise a new interrupt will be generated directly after you enable interrupts again with EI. Because that disables that particular interrupt at the same time, you may have to write a second value to this port to reenable it.

Revision as of 08:18, 3 April 2005

Synopsis

Port Number: 03h

Function: Interrupt Control Port

This port controls all devices that can generate interrupts.

Read Values

  • Bit 0: Set if the ON key generated an interrupt.
  • Bit 1: Set if the first hardware timer generated an interrupt.
  • Bit 2: Set if the second hardware timer generated an interrupt.
  • Bit 3: Reset if the ON key is being pressed; set otherwise.
  • Bit 4-7: Unused.

Write Values

  • Bit 0: Set 0 to disable ON key interrupts and to acknowledge an ON key interrupt. Set 1 to enable ON key interrupts.
  • Bit 1: Set 0 to disable interrupts from the first timer and to acknowledge an interrupt from the first timer. Set 1 to enable interrupts from the first timer.
  • Bit 2: Set 0 to disable interrupts from the second timer and to acknowledge an interrupt from the second timer. Set 1 to enable interrupts from the second timer.
  • Bit 3: Set 0 to turn off the LCD. Set 1 to enable the LCD.
  • Bit 4-7: Unused.

Comments

  • You need to acknowledge interrupts. Otherwise a new interrupt will be generated directly after you enable interrupts again with EI. Because that disables that particular interrupt at the same time, you may have to write a second value to this port to reenable it.