84PCE:OS:Serial Flash Commands

The Python Edition calculator contains a new serial flash chip with an entirely new interface. For pre-Python calculators see the old parallel interface.

For reference, pages are 256 bytes, sectors are 4KB, and blocks are 64KB.

Basic Flash Commands

You write a command to the range $E00800-$E0080F and then wait until $E00824 bit 0 is set at which point you acknowledge by setting the same bit.

Erasing

00000000 00000001 00000000 02000006 |
XXXXXXXX 03000001 00000000 020000D8 | X is the address of the block to erase.
00000000 00000001 00000000 04000005 |

Writing

Writes can only happen within a single page at a time.

00000000 00000001 00000000 02000006 |
XXXXXXXX 03000001 YYYYYYYY 42000032 | X is the address to write to, Y is the number of bytes to write (maximum 256)
Write each byte to $E00900, followed by a normal wait.