Port Number: 00h
This port controls the calculator's serial link port (the standard link port present on the 83+, 83+ SE, 84+ and 84+ SE - do not confuse this with the 84+/84+SE's USB link port).
- Bits 0 and 1: These bits indicate the state of the link port's two lines. If a bit is set that indicates the line is high, and if it is reset that indicates the line is low. When idle (no transfer in progress, no cable plugged in, etc), both lines are usually high. When a cable is connected on both ends, a line reads high if and only if both ends have set the line high. The line will read low if either calculator sets it low. Bit 0 is the tip and bit 1 is the ring.
- 83+ only: Bit 2: Set means link receive assist is active.
- 83+ only: Bit 3: Set when link assist has received a complete byte. The only way to reset this bit is to read port 5.
- Bit 4 and 5: Bits 4 and 5 indicate which lines are pulled low by the calculator (unlike bits 0 and 1 they are not influenced by the other calculator). A 1 bit indicates your calculator is holding the line low. A 0 bit indicates your calculator is not holding the line low. (When both calculators have a 0 bit here, the corresponding line will read 1.) In other words, these bits reflect bits 0 and 1 from the most recent write to this port.
- Bits 0 and 1: Setting a bit will pull the line low. Resetting a bit will stop holding the line low (allowing it to go high if the other calculator is not holding it low). Remember a low line will read as a bit being reset, but when writing setting a bit brings the line low.
- 83+ only: Bit 2: Set this bit to enable the link receive assist. After setting this bit, poll port 0 until bit 3 is high, at which point read from port 5 to get the byte.
One thing to keep in mind when writing link port related software is that the Ti-OS checks for silent transfers in the background of input routines. When two calculators are connected and one pulls a line low, the other calculator will respond by pulling the other line low to acknowledge that it has received a bit. Even when the other calculator is running an assembly program that uses the getkey romcall. This phenomenon is known to cause severe headaches for programmers who attempt to write synchronization routines :).
Other useful information on linking in general:
- TI Link Protocol & File Format Guide
- Ti-83 Link Port Tutorial
- All about the Ti-86 link port
- Bell and CLAP projects
ld a,0 ; Set both lines high out (0),a ld a,2 ; Set tip high, ring low out (0),a ld a,1 ; Set tip low, ring high out (0),a ld a,3 ; Set both low out (0),a
in a,(0) ; Get link port value bit 0,a ; Check tip jr z,tip_low jr nz,tip_high bit 1,a ; Check ring jr z,ring_low jr nz,ring_high