Difference between revisions of "83Plus:Ports:5B"
From WikiTI
(Port 5B - enable/disable protocol interrupts) |
(No difference)
|
Revision as of 17:16, 5 September 2010
Synopsis
Port Number: 5Bh
Function: USB Protocol Interrupt Enable
This port controls whether interrupts should be generated for USB protocol events.
| This port only exists on the the TI-84 Plus and the TI-84 Plus Silver Edition. On the standard TI-83 Plus, it acts as a shadow of port 11. On the TI-83 Plus Silver Edition, this port has no effect. |
Read Values
- Bit 0: Set if USB protocol interrupts are enabled.
- Bit 1: Always 0
- Bit 2: Unknown
- Bits 3-7: Always 0
Write Values
- Bit 0: Set to allow USB protocol interrupts
- Bit 1: Not used
- Bit 2: Unknown
- Bits 3-7: Not used
Comments
When this port is set to 1, the USB controller will generate an interrupt whenever a USB transaction finishes, as well as for various other USB-protocol-related events.
When such an interrupt occurs, port 55 bit 4 will be cleared. Ports 82, 84, and 86 (and possibly 83 and 85) will tell you what event(s) caused the interrupt. Reading from any of these ports also clears it and acknowledges the interrupt.
