Difference between revisions of "83Plus:Ports:29"
From WikiTI
(added 2e info) |
(added warning about lcd not updating.) |
||
| Line 12: | Line 12: | ||
* Bit 0 enables the effects of the flash delay controlled by port 2E. | * Bit 0 enables the effects of the flash delay controlled by port 2E. | ||
* Bit 1 enables the effects of the ram delay controlled by port 2E. | * Bit 1 enables the effects of the ram delay controlled by port 2E. | ||
| − | * Bits 2-7 control the amount of delay added at specified instructions. To calculate the number of clock cycles added, divide the contents of port 29 by 4 and round off. | + | * Bits 2-7 control the amount of delay added at specified instructions. To calculate the number of clock cycles added, divide the contents of port 29 by 4 and round off. '''NOTE:''' The contents of this port should NOT be less than 0Ch or the LCD will no longer update. |
== Comments == | == Comments == | ||
Revision as of 06:05, 14 March 2006
| This port only exists as a distinct port on the TI-83 Plus Silver Edition, the TI-84 Plus, and the TI-84 Plus Silver Edition. On the standard TI-83 Plus, it acts as a shadow of port 01. |
Synopsis
Port Number: 29h
Function: LCD Delay (6 MHz)
This port removes the amount of delay needed between accesses to the LCD driver by adding a delay to any instruction which reads from or writes to ports 10 or 11, as well as the mirror ports 12 and 13.
Usage
- Bit 0 enables the effects of the flash delay controlled by port 2E.
- Bit 1 enables the effects of the ram delay controlled by port 2E.
- Bits 2-7 control the amount of delay added at specified instructions. To calculate the number of clock cycles added, divide the contents of port 29 by 4 and round off. NOTE: The contents of this port should NOT be less than 0Ch or the LCD will no longer update.
Comments
This port is not available on the normal TI-83+. On the normal TI-83+ this port is a shadow of Port 01h.
Bits 0&1 are reset on the 83+SE and set on the 84+(se).
The effect of this port is only seen if the contents of port 20h equals 00.
