Difference between revisions of "83Plus:Ports:29"
From WikiTI
Thepenguin77 (Talk | contribs) m |
Thepenguin77 (Talk | contribs) m |
||
| Line 1: | Line 1: | ||
[[Category:83Plus:Ports:By Address|29 - LCD Delay (6 MHz)]] [[Category:83Plus:Ports:By Name|LCD Delay (6 MHz)]] | [[Category:83Plus:Ports:By Address|29 - LCD Delay (6 MHz)]] [[Category:83Plus:Ports:By Name|LCD Delay (6 MHz)]] | ||
| − | {{SE-Only Port| | + | {{SE-Only Port|01}} |
== Synopsis == | == Synopsis == | ||
Revision as of 20:49, 27 October 2011
| This port only exists as a distinct port on the TI-83 Plus Silver Edition, the TI-84 Plus, and the TI-84 Plus Silver Edition. On the standard TI-83 Plus, it acts as a shadow of port 01. |
Synopsis
Port Number: 29h
Function: LCD Delay (6 MHz)
This port removes the amount of delay needed between accesses to the LCD driver by adding a delay to any instruction which reads from or writes to ports 10 or 11, as well as the mirror ports 12 and 13.
Usage
- Bit 0 enables the effects of the flash delay controlled by port 2E.
- Bit 1 enables the effects of the ram delay controlled by port 2E.
- Bits 2-7 control the amount of delay added at specified instructions. To calculate the number of clock cycles added, divide the contents of port 29 by 4 and round off. NOTE: The contents of this port should NOT be less than 0Ch or the LCD driver will no longer respond.
Comments
This port is not available on the normal TI-83+. On the normal TI-83+ this port is a shadow of Port 01h.
Bits 0&1 are reset on the 83+SE and set on the 84+(se).
The effect of this port is only seen if the contents of port 20h equals 00.
