Difference between revisions of "83Plus:Ports:29"
(→Values) |
m (→Values) |
||
| Line 21: | Line 21: | ||
For a simple table of common values: | For a simple table of common values: | ||
| − | <nowiki>Value | + | <nowiki>Value Relative speed (100% is normal, 200% would mean the LCD is twice as fast) |
17 100% | 17 100% | ||
27 110% | 27 110% | ||
Revision as of 19:15, 4 April 2005
| This port only exists as a distinct port on the TI-83 Plus Silver Edition, the TI-84 Plus, and the TI-84 Plus Silver Edition. On the standard TI-83 Plus, it acts as a shadow of port 09. |
Synopsis
Port Number: 29h
Function: LCD Speed (6 MHz)
This port controls the calculator's LCD speed when it is running at 6 MHz. It is complicated and the lower four bits have not been thoroughly investigated but should be 7h on the TI-83/84 Plus Silver Edition at all times.
Values
Setting bits 4-7 on this port has the effect of shortening the required LCD delay. Bits 7-5 control the removed delay in powers of 2 (i.e. setting bit 7 removes 1/2 of the original delay, setting bit 6 removes 1/4, and bit 5 1/8). Bit 4 is related to bits 7-5 by a factor of 3/26. If the entire upper nibble of port 29h is zero, the LCD will not update.
The formula below calculates the amount of delay removed by setting bits 7-4 (the lower nibble of the port should always be 7). b7, b6, b5, b4 are either 0 or 1 and represent the value of their corresponding bit.
Percentage of delay removed [0-1] = (b7/2) + (b6/4) + (b5/8) + (3/26)(b7)(b4) + (3/52)(b6)(b4) + (3/104)(b5)(b4).
Note however if port 29h is set to 27h, then the % of delay removed is actually (1/8) - (3/104).
For a simple table of common values:
Value Relative speed (100% is normal, 200% would mean the LCD is twice as fast) 17 100% 27 110% 47 133% 67 160% 87 200% A7 267% C7 400% E7 1300% F7 1600%
Comments
This port is not available on the normal TI-83+. On the normal TI-83+ this port is a shadow of Port 09h.
Credits and Contributions
- Michael Vincent: Documentation as found here.
